The 42mm × 42mm × 28mm End Feed Reducing Tee runs straight through at 42mm and takes a reduced 28mm branch at 90°. A reduced-branch tee — for taking a 28mm branch off a 42mm commercial riser or header. Soldered capillary joints on all three ends. Manufactured to BS EN 1254-1 and fits copper tube to BS EN 1057.

This is a reduced-branch tee — the run is 42mm, the branch reduces to 28mm.

Also known as: reducing tee, branch reduced tee, reducing branch tee, unequal tee, 42x42x28 tee, endfeed reducing tee.

• Manufactured to BS EN 1254-1 for capillary (solder) fittings
• Reduced-branch tee — 42mm × 42mm × 28mm
• Fits copper tube to BS EN 1057
• WRAS approved
• Solder and flux required — not supplied
• Sold individually — buy exactly what the job needs
• Suitable for hot and cold water and heating services

End feed means a capillary joint: clean the tube and fitting, apply flux, heat evenly and feed lead-free solder to the mouth of the fitting until a ring forms. See our guide: How to solder end feed fittings.

Also in this range: equal tees, couplers and the full end feed range. Ordering for a whole job? Use the bulk fittings matrix.