The 10mm End Feed Equal Tee splits a 10mm copper run three ways — two ends in line and one branch at 90°, all 10mm. Used to take a 10mm branch off a 10mm microbore heating run. Soldered capillary joints on all three ends. Manufactured from copper to BS EN 1254-1 and fits copper tube to BS EN 1057.

This is an equal tee — all three connections are the same size (10mm).

Also known as: equal tee, tee piece, 90 degree tee, branch tee, T fitting, 10mm tee, endfeed tee.

• Manufactured to BS EN 1254-1 for capillary (solder) fittings
• Equal tee — 10mm × 10mm × 10mm
• Fits copper tube to BS EN 1057
• WRAS approved
• Solder and flux required — not supplied
• Sold individually — buy exactly what the job needs
• Suitable for hot and cold water and heating services

End feed means a capillary joint: clean the tube and fitting, apply flux, heat evenly and feed lead-free solder to the mouth of the fitting until a ring forms. See our guide: How to solder end feed fittings.

Also in this range: couplers, elbows and the full end feed range. Ordering for a whole job? Use the bulk fittings matrix.