masterflow

The 1" × 28mm End Feed Imperial/Metric Adaptor joins imperial 1" copper tube to a 28mm metric fitting or run with a soldered capillary joint. It ti...

The 10mm End Feed 90° Elbow turns a run of 10mm copper tube through a right angle with a soldered capillary joint. Used on 10mm microbore heating p...

The 10mm End Feed Equal Tee splits a 10mm copper run three ways — two ends in line and one branch at 90°, all 10mm. Used to take a 10mm branch off ...

The 10mm End Feed Stop End caps off a 10mm copper pipe with a single soldered capillary joint — for terminating microbore runs and capped-off radia...

The 10mm End Feed Street Elbow 90° turns a run of 10mm copper tube through a right angle, with one male (spigot) end and one female (socket) end. T...

The 10mm × 8mm End Feed Fitting Reducer is an internal reducer with a 10mm spigot end that pushes inside a 10mm fitting, and an 8mm socket that tak...

The 10mm × 8mm End Feed Reducing Coupler is an external reducer that joins 10mm copper tube to 8mm copper tube in a straight run with a soldered ca...

The 15mm End Feed 45° Obtuse Elbow turns a run of 15mm copper tube through 45° with a soldered capillary joint. The gentler bend eases pipework aro...

The 15mm End Feed 45° Obtuse Street Elbow turns a run of 15mm copper tube through 45°, with one male (spigot) end and one female (socket) end. The ...

The 15mm End Feed 90° Elbow turns a run of 15mm copper tube through a right angle with a soldered capillary joint. The everyday elbow on domestic s...

The 15mm End Feed Air Vent Cap caps a 15mm copper tube end with a manual air vent — a soldered capillary socket with a vent screw for releasing tra...

The 15mm End Feed Equal Tee splits a 15mm copper run three ways — two ends in line and one branch at 90°, all 15mm. The everyday branch tee on dome...

The 15mm End Feed Full Crossover lets one 15mm copper pipe pass cleanly over another with a full factory-formed offset — soldered capillary socket ...

The 15mm End Feed Long Radius Street Elbow turns a run of 15mm copper tube through 90° on a long, sweeping radius, with one male (spigot) end and o...

The 15mm End Feed Part Crossover lets one 15mm copper pipe pass over another without notching or bending on site — a factory-formed offset with a s...

The 15mm End Feed Slip Coupler joins two lengths of 15mm copper tube in a straight run with a soldered capillary joint. Unlike a standard coupler i...

The 15mm End Feed Stop End caps off a 15mm copper pipe with a single soldered capillary joint — the everyday cap for terminating redundant hot and ...

The 15mm End Feed Street Elbow 90° turns a run of 15mm copper tube through a right angle, with one male (spigot) end and one female (socket) end. T...

The 15mm × 10mm End Feed Fitting Reducer is an internal reducer with a 15mm spigot end that pushes inside a 15mm fitting, and a 10mm socket that ta...

The 15mm × 10mm End Feed Long Tail Fitting Reducer is an internal reducer with an extended 15mm spigot (the long tail) that pushes inside a 15mm fi...

The 15mm × 10mm End Feed Reducing Coupler is an external reducer that joins 15mm copper tube to 10mm copper tube in a straight run with a soldered ...

The 15mm × 12mm End Feed Fitting Reducer is an internal reducer with a 15mm spigot end that pushes inside a 15mm fitting, and a 12mm socket that ta...