The 54mm End Feed 45° Obtuse Elbow turns a run of 54mm copper tube through 45° with a soldered capillary joint. The largest 45° elbow in the range — the gentler bend eases 54mm plant room headers and commercial risers around obstructions and offsets without the sharp change of a 90° elbow. Manufactured from copper to BS EN 1254-1 and fits copper tube to BS EN 1057.

Also known as: obtuse elbow, 45 degree elbow, 45° bend, obtuse bend, half bend, offset elbow, 54mm obtuse elbow, endfeed 45 elbow.

• Manufactured to BS EN 1254-1 for capillary (solder) fittings
• Changes direction of 54mm tube by 45°
• Fits copper tube to BS EN 1057
• WRAS approved
• Solder and flux required — not supplied
• Sold individually — buy exactly what the job needs
• Suitable for hot and cold water and heating services

End feed means a capillary joint: clean the tube and fitting, apply flux, heat evenly and feed lead-free solder to the mouth of the fitting until a ring forms. See our guide: How to solder end feed fittings.

Also in this range: 90° elbows, couplers and the full end feed range. Ordering for a whole job? Use the bulk fittings matrix.