54mm × 42mm × 42mm End Feed Reducing Tee (Reduced End & Branch) — Copper
The 54mm × 42mm × 42mm End Feed Reducing Tee connects 54mm and 42mm in line (the run) with a 42mm branch at 90°. A reduced end-and-branch tee — off the 54mm inlet, one run end steps down to 42mm and the branch is a reduced 42mm. The largest end-and-branch tee in the range, for plant room headers and commercial risers. Soldered capillary joints on all three ends. Manufactured to BS EN 1254-1 and fits copper tube to BS EN 1057.
This is a reduced end-and-branch tee — a run end (42mm) and the branch (42mm) are both reduced from the 54mm end.
Also known as: reducing tee, end and branch reduced tee, double reducing tee, unequal tee, 54x42x42 tee, endfeed reducing tee.
- Manufactured to BS EN 1254-1 for capillary (solder) fittings
- Reduced end-and-branch tee — 54mm × 42mm × 42mm
- Fits copper tube to BS EN 1057
- WRAS approved
- Solder and flux required — not supplied
- Sold individually — buy exactly what the job needs
- Suitable for hot and cold water and heating services
End feed means a capillary joint: clean the tube and fitting, apply flux, heat evenly and feed lead-free solder to the mouth of the fitting until a ring forms. See our guide: How to solder end feed fittings.
Also in this range: equal tees, couplers and the full end feed range. Ordering for a whole job? Use the bulk fittings matrix.
